Configuring Ip And Mac Address Validation For Static Interfaces - Juniper ACX1000 Configuration Manual

Configuring IP and MAC Address Validation for Static Interfaces

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
This topic describes how to configure IP and MAC address validation for static interfaces
on ACX Series routers.
Subscriber interfaces can be statically created and associated with a dynamic profile
(for example, VLAN interfaces).
To configure IP and MAC address validation on static interfaces, include the
statement at the
[edit interfaces interface-name unit logical-unit-number family inet]
hierarchy level.
Configure the static VLAN interface.
1.
[edit interfaces]
user@host# edit interface-name unit logical-unit-number family inet
Configure the type of IP and MAC address validation for the interface.
2.
To configure loose validation:
[edit interfaces interface-name unit logical-unit-number family inet]
user@host# set mac-validate
To configure strict validation:
[edit interfaces interface-name unit logical-unit-number family inet]
user@host# set mac-validate
For example, to configure loose validation on interface fe-0/0/0.0, configure the following:
[edit interfaces fe-0/0/0 unit 0 family inet]
user@host# set mac-validate
To check packets dropped by IP and MAC address validation, use the run show interfaces
interface-name statistics show command.
IP and MAC Address Validation in ACX Series on page 995
mac-validate on page 1593
Chapter 30: Configuring IP and MAC Address Validation
loose
strict
loose
mac-validate
997