Juniper ACX1000 Configuration Manual page 1345

Copyright © 2017, Juniper Networks, Inc.
On PE-r Router PE3, configure the BGP-based VPLS routing instance by including
3.
the statement at the
instance-type
and specifying the
vpls
Gigabit Ethernet interface connected to Router CE3. Configure a route distinguisher
to ensure that the route advertisement is unique by including the
statement and specifying
and forwarding (VRF) route target to be included in the route advertisements to
the other routers participating in the VPLS. To configure the VRF route target, include
the vrf-target statement and specify
the
no-tunnel-services
if the device does not have tunnel services. The
omitted in this example. Optionally, you can include the
specify an upper limit on the maximum site identifier that can be accepted to allow
a pseudowire to be brought up. The
We recommend using the default of 65,534.
Configure the VPLS protocol and the mesh groups for each MTU PE device.
To configure the VPLS protocol, include the
routing-instances H-VPLS protocols]
specify a name for the site. Include the
Ethernet interface connected to Device CE3.
Configuring mesh groups under the VPLS instance terminates the Layer 2 circuit
into the VPLS instance. To configure each mesh group, include the
statement and specify the mesh group name. In this example, the mesh group name
is the name of the MTU device associated with each mesh group. Include the
statement and specify the ID that matches the virtual circuit ID configured in
"Configuring the Spoke MTU PE Routers" on page
statement and specify the IP address of the spoke PE router associated with each
mesh group. Optionally, include the
a full mesh of VPLS connections. The
configuring a single mesh group and terminating multiple Layer 2 circuit pseudowires
into it. The
local-switching
routing-instances {
H-VPLS {
instance-type vpls;
interface ge-2/1/3.0;
route-distinguisher 192.0.2.3:33;
vrf-target target:64510:2;
protocols {
vpls {
site pe3 {
site-identifier 3;
interface ge-2/1/3.0;
}
mesh-group pe1 {
vpls-id 100;
neighbor 192.0.2.1;
}
mesh-group pe2 {
vpls-id 200;
Chapter 35: Configuring Virtual Private LAN Service
[edit routing-instances H-VPLS]
option. Include the
interface
as the value. Also configure the VPN routing
192.0.2.3:33
target:64510:2
statement to enable the use of LSI interfaces, which is useful
no-tunnel-services
statement is omitted in this example.
site-range
vpls
hierarchy level. Include the
interface statement and specify the Gigabit
local-switching
local-switching
statement is omitted in this example.
hierarchy level
statement and specify the
route-distinguisher
as the value. Optionally, include
statement is
site-range statement to
statement at the
[edit
statement and
site
mesh-group
1284. Also include the
neighbor
statement if you are not using
statement is useful if you are
vpls-id
1287