Managed Objects For Jnxsoamlmthresholdcfgtable - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Managed Objects for jnxSoamLmThresholdCfgTable

Table 99: jnxSoamLmThresholdCfgTable
Object
jnxSoamLmThresholdCfgIndex
1216
The jnxSoamLmThresholdCfgTable
, contains the
5} jnxSoamLmThresholdCfgEntry
measurement (ETH-LM) configuration threshold values. Each
jnxSoamLmThresholdCfgEntry
1} , contains the objects listed in the following table.
The
jnxSoamLmThresholdCfgTable
threshold values for LM Performance Monitoring. The main purpose of the threshold
configuration table is to configure threshold alarm notifications indicating that a specific
performance metric is not being met. Each row in the table represents a Loss Measurement
session threshold set for the defined MEP. This table uses five indices. The first three
indices are the indices of the Maintenance Domain, MaNet, and MEP tables. The fourth
index is the specific LM session on the selected MEP. The fifth index is the specific
threshold set number. Rows in this table are not created automatically. A row is created
in this table to set up a threshold set on a configured MEP that has a configured LM
session. If two managers try to 'create' the same row at the same time, the first creation
would succeed, the second creation attempt would result in an error. The second creation
attempt would then need to select a new index value to successfully create a new row.
An NE needs to support at least one threshold set for NE SOAM PM compliance. A second
threshold set on the NE is desirable. More than two threshold sets can be configured on
the NE if supported on the NE. All the objects in the row have a default value that disables
the particular threshold measurement. In order to enable a threshold measurement the
particular bit in the jnxSoamLmThresholdCfgEnable object is to be set to '1' and the
selected threshold measurement is to have a threshold value configured. Non-configured
threshold measurements are disabled by default. The writable objects in this table need
to be persistent upon reboot or restart of a device.
Object ID
jnxSoamLmThresholdCfgEntry 1
, whose object identifier is
that signifies the Ethernet loss
, whose object identifier is
{jnxSoamLmThresholdCfgTable
contains the list of Loss Measurement configuration
Description
Denotes the index of the threshold
number for the specific LM threshold
entry. An index value of '1' needs to be
supported. Other index values can also
be supported.
Copyright © 2017, Juniper Networks, Inc.
{jnxSoamPmDmObjects