Juniper ACX1000 Configuration Manual page 801

Copyright © 2017, Juniper Networks, Inc.
Enable traffic engineering for OSPF.
16.
[edit protocols]
user@PCC# set ospf traffic-engineering
Define the PCE that Router PCC connects to, and configure the the PCE parameters.
17.
[edit protocols]
user@PCC# set pcep pce pce1 local-address 10.102.180.228
user@PCC# set pcep pce pce1 destination-ipv4-address 10.102.180.246
user@PCC# set pcep pce pce1 destination-port 4189
user@PCC# set pcep pce pce1 pce-type active
user@PCC# set pcep pce pce1 pce-type stateful
user@PCC# set pcep pce pce1 lsp-provisioning
user@PCC# set pcep pce pce1 lsp-cleanup-timer 0
user@PCC# set pcep pce pce1 delegation-cleanup-timeout 60
Configure Router PCC to enable point-to-multipoint LSP capability for external
18.
path computing.
[edit protocols]
set pcep pce pce1 p2mp-lsp-report-capability
Configure the traffic engineering policy.
19.
[edit policy-options]
user@PCC# set policy-statement TE term 1 from family traffic-engineering
user@PCC# set policy-statement TE term 1 then accept
Results
From configuration mode, confirm your configuration by entering the
show protocols commands. If the output does not display the intended configuration,
repeat the instructions in this example to correct the configuration.
user@PCC# show interfaces
ge-0/0/0 {
unit 0 {
family inet {
address 1.2.4.1/30;
}
family mpls;
}
}
ge-0/0/1 {
unit 0 {
family inet {
address 1.2.3.1/30;
}
family mpls;
}
}
ge-0/0/2 {
unit 0 {
Chapter 23: Configuring Path Computation Element Protocol (PCEP)
and
show interfaces
743