Juniper ACX1000 Configuration Manual page 1105

Table 68: Firewall Filter Match Conditions by Protocol Family
Traffic Type Hierarchy Level at Which Match Conditions Are Specified
Protocol-independent
[edit firewall family any filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for
Protocol-Independent Traffic.
IPv4
[edit firewall family inet filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for IPv4 Traffic.
IPv6
[edit firewall family inet6 filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for IPv6 Traffic.
MPLS
[edit firewall family mpls filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS Traffic.
IPv4 addresses
[edit firewall family mpls filter filter-name term term-name ip-version ipv4 ]
in MPLS flows
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv4 ports in MPLS flows
[edit firewall family mpls filter filter-name term term-name ip-version ipv4 protocol (tcp | udp)]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv6 addresses
[edit firewall family mpls filter filter-name term term-name ip-version ipv6 ]
in MPLS flows
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv6 ports in MPLS flows
[edit firewall family mpls filter filter-name term term-name ip-version ipv6 protocol (tcp | udp)]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
VPLS
[edit firewall family vpls filter filter-name term term-name]
For the complete list of match conditions, see
on page
Layer 2 CCC [edit firewall family ccc filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for Layer 2 CCC Traffic.
Copyright © 2017, Juniper Networks, Inc.
For MPLS-tagged IPv6 traffic, you specify the term's IPv6 address-specific match
conditions under the
ip-version ipv6
conditions under the
protocol (tcp | udp)
Table 68 on page 1047 describes the types of traffic for which you can configure firewall
filters.
1070.
Chapter 32: Configuring Firewall Filters
statement and the term's IPv6 port-specific match
statement.
"Firewall Filter Match Conditions for VPLS Traffic"
1047