Juniper ACX1000 Configuration Manual page 962

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
904
set class-of-service traffic-control-profiles profile-2 atm-service cbr
set class-of-service traffic-control-profiles profile-2 peak-rate 1k
set class-of-service interfaces at-0/0/16 unit 0 output-traffic-control-profile profile-1
set interfaces at-0/0/16 per-unit-scheduler
set class-of-service traceoptions file cos
set class-of-service traceoptions file size 1000000000
set class-of-service traceoptions flag all
Configuring Shaping on an ATM IMA Pseudowire
The following steps require you to navigate various levels in the configuration hierarchy.
For information about navigating the CLI, see Using the CLI Editor in Configuration Mode
in the CLI User Guide.
To configure shaping on an ATM IMA pseudowire:
In configuration mode, go to the
1.
[edit]
user@host# edit class-of-service
Specify the first traffic control profile:
2.
[edit class-of-service]
user@host# edit traffic-control-profiles profile-1
Specify the ATM real-time variable bit rate
3.
[edit class-of-service traffic-control-profiles profile-1]
user@host# set atm-service rtvbr
Define the largest number of cells per second that the shaper processes before it
4.
drops packets:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set peak-rate 5k
Define the normal traffic rate averaged over time, from 61 cps through 38,641 cps:
5.
[edit class-of-service traffic-control-profiles profile-1]
user@host# set sustained-rate 3k
Define the maximum number of cells that a burst of traffic can contain, from 1
6.
through 4000 cells:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set max-burst-size 400
Specify the second traffic control profile:
7.
[edit class-of-service traffic-control-profiles profile-2]
user@host# edit traffic-control-profiles profile-2
hierarchy level:
[edit class-of-service]
rtvbr service traffic category:
Copyright © 2017, Juniper Networks, Inc.