Monitoring Tcam Resource Usage - Juniper ACX1000 Configuration Manual

Table 82: Features Using TCAM Resource (continued)
TCAM Apps/TCAM Users
napt-reverse-fil
no-local-switching
ptpoe
ptpoe-cos-rw
rfc2544-layer2-in
rfc2544-layer2-out
service-filter-in

Monitoring TCAM Resource Usage

Table 83: Show and Clear Commands to Monitor and Troubleshoot Dynamic TCAM
Task
Display the shared and the related applications for a particular application
Display the TCAM resource usage for an application and stages (egress, ingress, and
pre-ingress)
Display the TCAM resource usage errors for applications and stages (egress, ingress,
and pre-ingress)
Clears the TCAM resource usage error statistics for applications and stages (egress,
ingress, and pre-ingress)
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Feature/Functionality
Reverse filters for network address port translation (NAPT) service
NOTE: This feature is not supported on ACX5048 and ACX5096
routers.
Bridge no-local-switching
Point-to-Point-Over-the-Ethernet traps
NOTE: This feature is not supported on ACX5048 and ACX5096
routers.
CoS rewrite for PTPoE
NOTE: This feature is not supported on ACX5048 and ACX5096
routers.
RFC2544 for Layer 2 service at ingress
RFC2544 for Layer 2 service at egress
NOTE: This feature is not supported on ACX5048 and ACX5096
routers.
Service filter at ingress
NOTE: This feature is not supported on ACX5048 and ACX5096
routers.
You can use the show and clear commands to monitor and troubleshoot dynamic TCAM
resource usage.
Table 83 on page 1161 summarizes the command-line interface (CLI) commands you can
use to monitor and troubleshoot dynamic TCAM resource usage.
TCAM Stage
Ingress
Ingress
Ingress
Egress
Pre-ingress
Egress
Ingress
Command
show pfe tcam app
show pfe tcam usage
show pfe tcam errors
clear pfe tcam-errors
1161