Juniper ACX1000 Configuration Manual page 1408

ACX Series Universal Access Router Configuration Guide
1350
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-id number
Configure the inner VLAN ID for the test frames. This parameter is valid only for a CCC
13.
or an Ethernet pseudowire family.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ivlan-id number
Configure the priority value for the IEEE 802.1p bit in the outer VLAN tag. The priority
14.
value is configured when the UNI interface is dual-tagged.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-priority value
Configure the priority value for the IEEE 802.1p bit in the inner VLAN tag. This
15.
configuration is optional.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ivlan-priority value
Configure the CFI value for the outer VLAN tag. This configuration is optional.
16.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-cfi value
Specify the source IPv4 address to be used in generated test frames. This parameter
17.
is optional for both
CCC
source-ipv4-address for an
transmit the test frames. If you do not configure the
family, the default value of 192.168.1.10 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-ipv4-address address
Specify the destination IPv4 address to be used in generated test frames.
18.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-ipv4-address address
Specify the source UDP port to be used in the UDP header for the generated frames.
19.
If you do not specify the UDP port, the default value of 4040 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-udp-port port-number
Specify the destination UDP port to be used in the UDP header for the generated
20.
frames. If you do not specify the UDP port, the default value of 4041 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-udp-port port-number
and families. If you do not configure the
inet
inet family, the source address of the interface is used to
for a
source-ipv4-address
Copyright © 2017, Juniper Networks, Inc.
CCC