Juniper ACX1000 Configuration Manual page 1291

Table 102: jjnxSoamPmNotifications Table (continued)
Object
Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
Object ID Description
In the case of thresholds applied to a
maximum or average measurement
counter, the previous measured value is
the value of the counter at the end of the
preceding Measurement Interval. In the
case of thresholds applied to the last
measured value, it is the previous
measured value. The management entity
that receives the notification can identify
the system from the network source
address of the notification, and can
identify the LM or DM session reporting
the threshold crossing by the indices in
the
jnxSoamPmNotificationCfgThresholdId
object, including dot1agCfmMdIndex,
dot1agCfmMaIndex,
dot1agCfmMepIdentifier, and the
jnxSoamLmCfgIndex or
jnxSoamDmCfgIndex.
An agent is not to generate more than
one jnxSoamLmThresholdCrossingAlarm
'notification-event' of a given type per LM
or DM session as specified by
jnxSoamPmNotificationCfgAlarmInterval.
A 'notification-event' is the transmission
of a single notification to a list of
notification destinations.
If additional threshold crossing events
occur within the
jnxSoamPmNotificationCfgAlarmInterval
period, then notification generation for
these changes are suppressed by the
agent until the current alarm interval
expires. At the end of an alarm interval
period, one notification-event is
generated if any threshold crossing
events occurred since the start of the
alarm interval period. In such a case,
another alarm interval period is started
right away.
1233