Juniper ACX1000 Configuration Manual page 1427

Configuring
Benchmarking Test
Parameters on Router
B
Step-by-Step
Procedure
Copyright © 2017, Juniper Networks, Inc.
set interfaces ge-0/0/0 vlan-tagging
set interfaces ge-0/0/0 unit 0 encapsulation vlan-ccc
set interfaces ge-0/0/0 unit 0 vlan-id 101
set services rpm rfc2544-benchmarking profiles test-profile throughput test-type
throughput
set services rpm rfc2544-benchmarking profiles test-profile throughput packet-size 64
set services rpm rfc2544-benchmarking profiles test-profile throughput test-duration 20
set services rpm rfc2544-benchmarking profiles test-profile throughput bandwidth-kbps
500
set services rpm rfc2544-benchmarking tests test-name test1 interface ge-0/0/0.1
set services rpm rfc2544-benchmarking tests test-name test1 test-profile throughput
set services rpm rfc2544-benchmarking tests test-name test1 mode initiate,terminate
set services rpm rfc2544-benchmarking tests test-name test1 family ccc
set services rpm rfc2544-benchmarking tests test-name test1 direction nni
set interfaces ge-0/0/4 vlan-tagging
set interfaces ge-0/0/4 unit 0 encapsulation vlan-ccc
set interfaces ge-0/0/4 unit 0 vlan-id 101
set services rpm rfc2544-benchmarking tests test-name test1 interface ge-0/0/4.1
set services rpm rfc2544-benchmarking tests test-name test1 mode reflect
set services rpm rfc2544-benchmarking tests test-name test1 reflector-port 25
set services rpm rfc2544-benchmarking tests test-name test1 mode family ccc
set services rpm rfc2544-benchmarking tests test-name test1 direction uni
Configuring Benchmarking Test Parameters on Router B
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode.
To configure the test parameters on Router A:
In configuration mode, go to the
1.
[edit]
user@host# edit interfaces
Configure the interface on which the test must be run.
2.
[edit interfaces]
user@host# edit ge-0/0/0
Configure VLAN tagging for transmission and reception of 802.1Q VLAN-tagged
3.
frames.
[edit interfaces ge-0/0/0]
user@host# set vlan-tagging
Configure a logical unit for the interface.
4.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
[edit interfaces] hierarchy level:
1369