Juniper ACX1000 Configuration Manual page 1378

ACX Series Universal Access Router Configuration Guide
Verification
Purpose
Action
Meaning
Purpose
1320
Confirm that the configuration is working properly.
Verifying the Layer 2 Circuit on page 1320
Checking the VPLS Connections on page 1320
Checking Connectivity on page 1322
Manually Triggering a Switch from the Active Pseudowire to the Redundant
Pseudowire on page 1322
Verifying the Layer 2 Circuit
Verify that Layer 2 circuit is operational on the MTU device.
From operational mode, enter the
user@PE1> show l2circuit connections
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
LD -- local site signaled down
RD -- remote site signaled down
Legend for interface status
Up -- operational
Dn -- down
Neighbor: 10.255.14.216
Interface
ge-2/0/5.601(vc 601)
Remote PE: 10.255.14.216, Negotiated control-word: No
Incoming label: 299904, Outgoing label: 800001
Negotiated PW status TLV: No
Local interface: ge-2/0/5.601, Status: Up, Encapsulation: VLAN
Neighbor: 10.255.14.225
Interface
ge-2/0/5.601(vc 601)
As expected, the Layer 2 circuit connection to Device PE3 is operational, and the
connection to Device PE2 is in standby mode.
Checking the VPLS Connections
Verify that the VPLS connections are operational on the PE-r devices.
show l2circuit connections
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
SP -- Static Pseudowire
RS -- remote site standby
XX -- unknown
Type St Time last up
rmt Up Oct 9 16:28:58 2012
Type St Time last up
rmt ST
Copyright © 2017, Juniper Networks, Inc.
command.
# Up trans
1
# Up trans