Juniper ACX1000 Configuration Manual page 1428

ACX Series Universal Access Router Configuration Guide
1370
[edit interfaces ge-0/0/0]
user@host# edit unit 0
Specify the encapsulation for Ethernet VLAN circuits.
5.
[edit interfaces ge-0/0/0 unit 0]
user@host# set encapsulation vlan-ccc
Configure the VLAN ID on the logical interface.
6.
[edit interfaces ge-0/0/0 unit 0]
user@host# set vlan-id 101
Go to the top level of the configuration command mode.
7.
[edit interfaces ge-0/0/0 unit 0]
user@host# top
In configuration mode, go to the
8.
[edit]
user@host# edit services
Configure a real-time performance monitoring service (RPM) instance.
9.
[edit services]
user@host# edit rpm
Configure an RFC 2544-based benchmarking test for the RPM instance.
10.
[edit services rpm]
user@host# edit rfc2544-benchmarking
Define a name for a test profile—for example, throughput.
11.
[edit services rpm rfc2544-benchmarking]
user@host# edit profiles test-profile throughput
Configure the type of test to be performed as throughput.
12.
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
user@host# set test-type throughput
Specify the size of the test packet as 64 bytes.
13.
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
user@host# set test-type packet-size 64
Specify the period—for example, 20 minutes—for which the test is to be performed
14.
in hours, minutes, or seconds by specifying a number followed by the letter h (for
hours), m (for minutes), or s (for seconds).
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
[edit services] hierarchy level.
Copyright © 2017, Juniper Networks, Inc.