ACX Series Universal Access Router Configuration Guide
714
Enable MPLS on all interfaces of Router PCC, excluding the management interface.
5.
[edit protocols]
user@PCC# set mpls interface all
user@PCC# set mpls interface fxp0.0 disable
Configure IS-IS on all interfaces of Router PCC, excluding the management interface.
6.
[edit protocols]
user@PCC# set isis level 1 disable
user@PCC# set isis interface all
user@PCC# set isis interface fxp0.0 disable
user@PCC# set isis interface lo0.0
Define the PCE that Router PCC connects to, and configure the IP address of the
7.
PCE.
[edit protocols]
user@PCC# set pcep pce pce1 destination-ipv4-address 10.209.57.166
Configure the destination port for Router PCC that connects to a PCE using the
8.
TCP-based PCEP.
[edit protocols]
user@PCC# set pcep pce pce1 destination-port 4189
Configure the PCE type.
9.
[edit protocols]
user@PCC# set pcep pce pce1 pce-type active
user@PCC# set pcep pce pce1 pce-type stateful
Results
From configuration mode, confirm your configuration by entering the
commands. If the output does not display the intended configuration,
show protocols
repeat the instructions in this example to correct the configuration.
user@PCC# show interfaces
ge-1/0/1 {
unit 0 {
family inet {
address 20.31.4.1/24;
}
family iso;
family mpls;
}
}
ge-1/1/1 {
unit 0 {
family inet {
address 20.31.1.1/24;
}
show interfaces
Copyright © 2017, Juniper Networks, Inc.
and