Juniper ACX1000 Configuration Manual page 1365

Copyright © 2017, Juniper Networks, Inc.
Configure the backup neighbor by including the
specifying the IPv4 address of the backup hub PE router. Router PE3 is the backup
neighbor in this example. Also include the
l2circuit neighbor 192.0.2.5 interface ge-1/0/0.0 backup-neighbor 192.0.2.3]
level.
[edit protocols]
l2circuit {
neighbor 192.0.2.5 {
interface ge-1/0/2.0 {
virtual-circuit-id 100;
encapsulation-type ethernet;
backup-neighbor 192.0.2.3 {
standby;
}
}
}
}
On Router PE4, configure the Layer 2 circuit by including the
3.
the hierarchy level. Include the
[edit protocols]
IPv4 address of the hub PE router. Configure the logical interface by including the
statement and specify the interface connected to Router CE4.
interface
Configure the virtual circuit ID by including the
specifying as the ID value at the
100
interface ge-1/2/0.0]
Configure the backup neighbor by including the
specifying the IPv4 address of the backup hub PE router. Router PE3 is the backup
neighbor in this example. Also include the
l2circuit neighbor 192.0.2.5 interface ge-1/2/0.0 backup-neighbor 192.0.2.3]
level.
[edit protocols]
l2circuit {
neighbor 192.0.2.5 {
interface ge-1/2/0.0 {
virtual-circuit-id 100;
backup-neighbor 192.0.2.3 {
standby;
}
}
}
}
Chapter 35: Configuring Virtual Private LAN Service
standby
neighbor
virtual-circuit-id
[edit protocols l2circuit neighbor 192.0.2.5
hierarchy level.
standby
statement and
backup-neighbor
statement at the
[edit protocols
hierarchy
l2circuit statement at
statement and specify the
statement and
statement and
backup-neighbor
statement at the [edit protocols
hierarchy
1307