Family Mpls - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

family mpls

Syntax
Hierarchy Level
Release Information
Description
Options
1518
family mpls {
all-labels;
label-1;
label-2;
label-3;
no-labels;
no-label-1-exp;
payload {
ether-pseudowire {
zero-control-word;
}
ip {
disable;
layer-3-only;
port-data {
source-msb;
source-lsb;
destination-msb;
destination-lsb;
}
}
}
}
[edit forwarding-options hash-key]
Statement introduced before Junos OS Release 7.4.
option introduced in Junos OS Release 8.0.
no-label-1-exp
label-3 and no-labels options introduced in Junos OS Release 8.1.
statement introduced in Junos OS Release 9.1 (M320 and T Series
ether-pseudowire
routers only); support extended to M120 and MX Series routers in Junos OS Release 9.4.
and
all-labels payload ip disable
Series Packet Transport Routers only).
zero-control-word option introduced in Junos OS Release 16.1 for the M Series, MX Series,
and PTX Series.
For aggregated Ethernet and SONET/SDH interfaces only, configure load balancing
based on MPLS labels and payload. Only the IPv4 protocol is supported.
family mpls —(Aggregated Ethernet interfaces, aggregated SONET/SDH interfaces, and
multiple equal-cost MPLS next hops only) Incorporate MPLS label and payload
information into the hash key for per-flow load balancing. Only the IPv4 protocol is
supported.
—(PTX Series Packet Transport Routers only) Up to eight MPLS labels are
all-labels
included in the hash key to identify the uniqueness of a flow in the Packet Forwarding
Engine. This is the default setting.
options introduced in Junos OS Release 12.1X48R2. (PTX
Copyright © 2017, Juniper Networks, Inc.