Juniper ACX1000 Configuration Manual page 1421

Step-by-Step
Procedure
Copyright © 2017, Juniper Networks, Inc.
user@host# set test-profile throughput
Specify the logical interface, ge-0/0/0.1, on which the RFC 2544-based
19.
benchmarking test is run.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface ge-0/0/0.1
Specify the test mode for the packets that are sent during the benchmarking test
20.
as initiation and termination.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode initiate-and-terminate
Configure the address type family,
21.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family inet
Configure the destination IPv4 address for the test packets.
22.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set dest-address 200.0.0.2
Specify the UDP port of the destination to be used in the UDP header for the
23.
generated frames as 4001.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set udp-port 4001
Start the benchmarking test on the initiator.
24.
user@host> test services rpm rfc2544-benchmarking test test1 start
After the test is successfully completed, it is automatically stopped at the initiator.
Configuring Benchmarking Test Parameters on Router B
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure the test parameters on Router B:
In configuration mode, go to the
1.
[edit]
user@host# edit interfaces
Configure the interface on which the test must be run.
2.
[edit interfaces]
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
, for the benchmarking test.
inet
[edit interfaces] hierarchy level:
1363