Juniper ACX1000 Configuration Manual page 1441

Verifying the Results of the Benchmarking Test for UNI Direction of an Ethernet Pseudowire
Service
Purpose
Action
Meaning
Copyright © 2017, Juniper Networks, Inc.
Configuring Benchmarking Test Parameters on Router B:
[edit interfaces]
ge-0/0/4 {
vlan-tagging;
unit 0 {
encapsulation vlan-ccc;
vlan-id 101;
}
}
[edit services rpm]
rfc2544-benchmarking {
# Note, When in reflector mode, test profile is not needed
tests {
test-name test1 {
interface ge-0/0/4.1;
mode reflect;
family ccc;
direction uni;
}
}
}
After you have configured the device, enter the
Examine the results of the benchmarking test that is performed on the configured service
between Router A and Router B.
Verifying the Benchmarking Test Results on page 1383
Verifying the Benchmarking Test Results
Verify that the necessary and desired statistical values are displayed for the benchmarking
test that is run on the configured service between Router A and Router B.
In operational mode, enter the
| active-tests | completed-tests | summary)
results of each category or state of the RFC 2544-based benchmarking test, such as
aborted tests, active tests, and completed tests, for each real-time performance
monitoring (RPM) instance.
The output displays the details of the benchmarking test that was performed. For more
information about the
run show services rpm rfc2544-benchmarking
see
show services rpm rfc2544-benchmarking
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
command in configuration mode.
commit
run show services rpm rfc2544-benchmarking (aborted-tests
command to display information about the
in the
CLI Explorer
operational command,
.
1383