Configuring Maintenance Association Intermediate Points In Acx Series - Juniper ACX1000 Configuration Manual

Related
Documentation

Configuring Maintenance Association Intermediate Points in ACX Series

Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)
A maintenance association is a set of MEPs configured with the same maintenance
association identifier and maintenance domain level.
hierarchical relationships between the Ethernet bridge, maintenance domains,
maintenance associations, and MEPs.
Figure 62: Relationship Among Bridges, Maintenance Domains,
Maintenance Associations, and MEPs
Understanding Ethernet OAM Link Fault Management for ACX Series Routers on page 1112
Configuring Ethernet Local Management Interface on ACX Series on page 1113
Ethernet Frame Delay Measurements Overview on page 1117
Ethernet Frame Loss Measurement Overview on page 1121
Maintenance Intermediate Point (MIP) provides monitoring capability of intermediate
points for services such as Layer 2 bridging, Layer 2 circuit, and Layer 2 VPN. ACX5048
and ACX5096 routers support MIPs for the Ethernet OAM 802.1ag CFM protocol. Use
the bridge-domain, interface, and mip-half-function MIP options to specify the MIP
configuration.
NOTE: ACX5048 and ACX5096 routers do not support MIP configuration
on VPLS services.
NOTE: Whenever a MIP is configured and a bridge domain is mapped to
multiple maintenance domains or maintenance associations, it is essential
that the mip-half-function
maintenance associations be the same.
To display MIP configurations, use the
mip (bridge-domain | instance-name | interface-name)
The following MIP configurations are supported in ACX5048 and ACX5096 routers:
Figure 62 on page 1129
value for all maintenance domains and
show oam ethernet connectivity-fault-management
command.
shows the
1129