Juniper ACX1000 Configuration Manual page 1401

Table 107: Parameter for test-name configuration (continued)
Parameters
disable-signature-check
dscp-code-points
family
forwarding-class
halt-on-prefix-down
ignore-test-interface-state
in-service
ivlan-cfi
ivlan-id
ivlan-priority
mode
Copyright © 2017, Juniper Networks, Inc.
Description
Disable signature verification on the received test frames.
Specify the value of the Differentiated Services (DiffServ) field. For example, 001111.
If a value is not specified, then '0' is used in IP header.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Configure the test family (
bridge | ccc | inet
This parameter is mandatory for mode
Specify the forwarding class to be used for test frames.
If specified, a prefix that moves to the down state causes the corresponding tests to be stopped.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
When the
ignore-test-interface-state
the test continues to run even if there are any occurrences of interface up or down events. This is
applicable to both initiator and reflector test modes.
If specified, only the data traffic corresponding to the test session is interrupted, rest of the data
traffic flow sent to and from the UNI port under test on the service are not affected.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
CFI bit used in the inner VLAN tag.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Configure inner VLAN ID for the test frames.
This parameter is valid only for family
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Configure the priority value for the IEEE 802.1p bit in the inner VLAN tag.
Range: 0 through 7.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
Specify the test mode (
ethernet-loopback
—Test frames are loopbacked to the measuring device after the source MAC
ethernet-loopback
address and the destination MAC addresses are swapped.
—Test frames are initiated and terminated at the same end. If you specify
initiate-and-terminate
this mode, then a reflector should be configured on the peer end to bring back the test frames.
—Test frames are reflected on the chosen service.
reflect
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
).
ethernet-loopback
parameter is configured for RFC2544 benchmarking tests,
mode.
ccc
, , or
initiate-and-terminate
).
reflect
1343