Ldp Bgp Interworking Platform Support; Configuring Fec 128 Vpls Mesh Groups For Ldp Bgp Interworking; Configuring Fec 129 Vpls Mesh Groups For Ldp Bgp Interworking - Juniper ACX1000 Configuration Manual

LDP BGP Interworking Platform Support

Configuring FEC 128 VPLS Mesh Groups for LDP BGP Interworking

Configuring FEC 129 VPLS Mesh Groups for LDP BGP Interworking

Copyright © 2017, Juniper Networks, Inc.
LDP BGP interworking is supported on the following Juniper Networks routers and routing
platforms:
ACX5048
ACX5096
M7i
M10i
M40e
M120
M320
MX Series routers
T Series routers
TX Matrix routers
EX Series switches
To configure FEC 128 LDP BGP interworking for VPLS, include the
in the VPLS routing instance configuration of the PE border router:
mesh-group mesh-group-name {
local-switching;
mac-flush [ explicit-mac-flush-message-options ];
neighbor address;
peer-as all;
vpls-id number;
}
You can include this statement at the following hierarchy levels:
[edit routing-instances routing-instance-name protocols vpls]
[edit logical-systems logical-system-name routing-instances routing-instance-name
protocols vpls]
Using the statement, configure each PE router that is a part of the mesh group.
neighbor
You must separate the LDP-signaled routers and the BGP-signaled routers into their own
respective mesh groups. The LDP-signaled routers can be divided into multiple mesh
groups. The BGP-signaled routers must be configured within a single mesh group for
each routing instance.
Configuration for a mesh group for FEC 129 is very similiar to the configuration for FEC
128.
Chapter 35: Configuring Virtual Private LAN Service
mesh-group
statement
1275