Juniper ACX1000 Configuration Manual page 1436

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
1378
Configuring Benchmarking Test Parameters on Router A
The following example requires you to navigate various levels in the configuration
hierarchy. For information about navigating the CLI, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure the test parameters on Router A:
In configuration mode, go to the
1.
[edit]
user@host# edit interfaces
Configure the interface on which the test must be run.
2.
[edit interfaces]
user@host# edit ge-0/0/0
Configure VLAN tagging for transmission and reception of 802.1Q VLAN-tagged
3.
frames.
[edit interfaces ge-0/0/0]
user@host# set vlan-tagging
Configure a logical unit and specify the protocol family as
4.
[edit interfaces ge-0/0/0]
user@host# edit unit 0 family inet
Specify the address for the logical interface.
5.
[edit interfaces ge-0/0/0 unit 0 family inet]
user@host# set address 200.0.0.1/24
Configure the VLAN ID on the logical interface as 101.
6.
[edit interfaces ge-0/0/0 unit 0]
user@host# set vlan-id 101
Go to the top level of the configuration command mode.
7.
[edit interfaces ge-0/0/0 unit 0]
user@host# top
In configuration mode, go to the
8.
[edit]
user@host# edit services
Configure a real-time performance monitoring service (RPM) instance.
9.
[edit services]
user@host# edit rpm
hierarchy level:
[edit interfaces]
inet
hierarchy level.
[edit services]
Copyright © 2017, Juniper Networks, Inc.
.