Standard Firewall Filter Terminating Actions On Acx Series Routers - Juniper ACX1000 Configuration Manual

Table 75: Standard Firewall Filter Match Conditions for MPLS Traffic on ACX Series Routers
Match Condition
exp number
Related
Documentation

Standard Firewall Filter Terminating Actions on ACX Series Routers

Table 76: Terminating Actions for Standard Firewall Filters on ACX Series Routers
Terminating
Action Description
Accept the packet.
accept
discard Discard a packet silently, without sending an Internet Control Message Protocol
(ICMP) message. Discarded packets are available for logging and sampling.
Copyright © 2017, Juniper Networks, Inc.
Table 75 on page 1063 describes the match conditions you can configure at the
family mpls filter filter-name term term-name from]
Description
Experimental (EXP) bit number or range of bit numbers in the MPLS header. For
can specify one or more values from 0 through 7 in decimal, binary, or hexadecimal format.
Guidelines for Configuring Firewall Filters on page 1044
Standard Firewall Filter Match Conditions and Actions on ACX Series Routers Overview
on page 1052
Standard Firewall Filter Terminating Actions on ACX Series Routers on page 1063
Standard Firewall Filter Nonterminating Actions on ACX Series Routers on page 1064
Standard stateless firewall filters support different sets of terminating actions for each
protocol family.
NOTE: ACX Series routers do not support the
Table 76 on page 1063 describes the terminating actions you can specify in a standard
firewall filter term.
Chapter 32: Configuring Firewall Filters
[edit firewall
hierarchy level.
number
action.
next term
Protocols
family any
family inet
family mpls
family ccc
family any
family inet
family mpls
family ccc
, you
1063