Configuring A Bridge Domain On Acx Series Routers - Juniper ACX1000 Configuration Manual

ACX Series Universal Access Router Configuration Guide

Configuring a Bridge Domain on ACX Series Routers

Related
Documentation
760
Configuring a Bridge Domain on ACX Series Routers on page 760
Configuring Q-in-Q Tunneling on ACX Series on page 771
Configuring VLAN Identifiers for Bridge Domains in ACX Series on page 764
Disabling MAC Learning for Bridge Domains on ACX Series on page 765
Configuring Static MAC Addresses for Logical Interfaces in a Bridge Domain in ACX
Series on page 766
Configuring the Size of the MAC Address Table for Bridge Domains in ACX Series on
page 766
A bridge domain must include a set of logical interfaces that participate in Layer 2 learning
and forwarding.
To configure a bridge domain, include the following statements:
[edit]
bridge-domains {
bridge-domain-name {
interface interface-name;
vlan-id (none | number);
vlan-id-list [ vlan-id-numbers ];
}
}
You cannot use the slash (/) character in bridge domain names. If you do, the configuration
does not commit and an error is generated.
For the statement, you can specify either a valid VLAN identifier or
vlan-id
To include one or more logical interfaces in the bridge domain, specify an interface name
for an Ethernet interface you configured at the
hierarchy level.
To configure a layer 2 logical interface to be included in a bridge domain, you can either
include the
encapsulation vlan-bridge
encapsulation ethernet-bridge
NOTE: A maximum of 1000 logical interfaces can be configured on a physical
interface. You can configure a maximum of 3000 bridge domains on an ACX
Series router.
Layer 2 Bridge Domains on ACX Series Overview on page 755
Q-in-Q Tunneling on ACX Series Overview on page 770
Layer 2 Learning and Forwarding for Bridge Domains Overview on page 759
[edit bridge-domains bridge-domain-name]
statement under the logical interface, or the
statement under the physical interface.
Copyright © 2017, Juniper Networks, Inc.
.
none