Juniper ACX1000 Configuration Manual page 1192

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
Results
1134
To configure IEEE 802.3ah OAM support on an interface:
Enable IEEE 802.3ah OAM support on an interface:
1.
[edit protocols oam ethernet link-fault-management]
user@router1# set interface (OAM Link-Fault Management) xe-0/0/0
Specify that the interface initiates the discovery process by setting the link discovery
2.
mode to active:
user@router# set interface xe-0/0/0 link-discovery active
Set the periodic OAM PDU-sending interval (in milliseconds) to 800:
3.
user@router# set interface xe-0/0/0 pdu-interval 800
Define the number of OAM PDUs to miss before an error is logged as 4:
4.
user@router# set interface xe-0/0/0 pdu-threshold 4
Configure the remote interface into loopback mode so that all frames except OAM
5.
PDUs are looped back without any changes:
user@router# set interface xe-0/0/0 remote-loopback
Configure remote loopback support for the local interface:
6.
user@router# set interface xe-0/0/0 negotiation-options allow-remote-loopback
Set the threshold count for sending frame error events to 30:
7.
user@router# set interface xe-0/0/0 event-thresholds frame-error 30
Set the threshold count for sending frame period error events to 50:
8.
user@router# set interface xe-0/0/0 event-thresholds frame-period 50
Configure the threshold count for sending frame period summary error events to
9.
40:
user@router# set interface xe-0/0/0 event-thresholds frame-period-summary
40
Set the threshold count for sending symbol period events to 20:
10.
user@router# set interface xe-0/0/0 event-thresholds symbol-period 20
Check the results of the configuration:
[edit]
Copyright © 2017, Juniper Networks, Inc.