Configuring The Optical Supervisory Channel In The Amplifier Chain When Using The Optical Inline Amplifier; Ptx3000 Integrated Photonic Line System - Juniper PTX3000 IPLC Features Manual

CHAPTER 6
Configuring the Optical Supervisory
Channel in the Amplifier Chain When
Using the Optical Inline Amplifier
Configuring the Optical Supervisory Channel Across the Amplifier Chain of the PTX3000
Integrated Photonic Line System
Copyright © 2018, Juniper Networks, Inc.
Configuring the Optical Supervisory Channel Across the Amplifier Chain of the PTX3000
Integrated Photonic Line System on page 33
Configuring the Anchor IPLC of the Amplifier Chain on page 34
Configuring the IP Address of the Anchor IPLC on page 35
Configuring the MAC Address of the Anchor IPLC on page 36
Configuring the Optical ILA Identification Number on page 37
Configuring the IP Address of an Optical Inline Amplifier on page 39
Configuring Optical ILA Authentication Through the Junos OS CLI on page 40
Upgrading the Optical Inline Amplifier from the Junos OS CLI on page 41
The optical supervisory channel (OSC) of the PTX3000 integrated photonic line system
automates control of the optical layer by providing control and management of the
remote IPLC. If you are using Juniper Networks optical inline amplifiers (ILA)s in the
amplifier chain, this automated control is extend to the entire amplifier chain. This
procedure describes how to configure the OSC on both the PTX3000 integrated photonic
line system and the optical ILA.
To configure the OSC in the PTX3000 integrated photonic line system and amplifier
chain:
Configure one of the IPLC modules in the line system as the anchor IPLC, see
1.
"Configuring the Anchor IPLC of the Amplifier Chain" on page
Configure a unique IP address on the anchor IPLC module, see
2.
Address of the Anchor IPLC" on page
34.
"Configuring the IP
35.
33