Copyright © 2017, Juniper Networks, Inc.
Specify the IPv4 address of the PCE to connect with.
6.
[edit protocols pcep pce pce-id]
user@PCC# set destination-ipv4-address ipv4-address
Specify the TCP port number that the PCE is using
7.
[edit protocols pcep pce pce-id]
user@PCC# set destination-port port-number
The value can range from 1 through 65535 and the default value is 4189.
Specify the amount of time (in seconds) that the PCC must wait before deleting any
8.
non-delegated PCE-initiated LSPs from the failed PCE after a PCEP session terminates.
[edit protocols pcep pce pce-id]
user@PCC# set lsp-cleanup-timer seconds
Configure the PCC to accept SPs that are externally provisioned by connected PCEs.
9.
By default, the PCC rejects PCE-initiated LSPs.
[edit protocols pcep pce pce-id]
user@PCC# set lsp-provisioning
Specify the number of unknown messages per minute that the PCC can receive at
10.
maximum after which the PCEP session is closed.
[edit protocols pcep pce pce-id]
user@PCC# set max-unknown-messages messages-per-minute
The value can range from 1 through 16384, and the default value is 0 (disabled or no
limit).
Specify the number of unknown requests per minute that the PCC can receive at
11.
maximum after which the PCEP session is terminated.
[edit protocols pcep pce pce-id]
user@PCC# set max-unknown-requests requests-per-minute
The value can range from 0 through 16384, and the default value is 5. A value of 0
disables this statement.
Configure the PCE type.
12.
[edit protocols pcep pce pce-id]
user@PCC# set pce-type active stateful
Specify the amount of time (in seconds) that the PCC must wait for a reply before
13.
resending a request.
[edit protocols pcep pce pce-id]
user@PCC# set request-timer seconds
The value can range from 0 through 65535 seconds.
Chapter 23: Configuring Path Computation Element Protocol (PCEP)
733