Juniper ACX1000 Configuration Manual page 1407

Copyright © 2017, Juniper Networks, Inc.
This parameter is optional for a CCC family. If you do not configure the destination
MAC address, the default value of 0x00:0x60:0x67:0x71:0xC6:0x62 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-mac-address address
Specify the destination MAC address used in generated test frames.
7.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-mac-address address
Specify the logical interface on which the RFC 2544-based benchmarking test is run.
8.
This is a local user-to-network interface (UNI) on behalf of which the test frames are
generated when the test direction is egress.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface interface-name
Specify the family for the benchmarking test.
9.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family bridge
Specify the test mode for the packets that are sent during the benchmarking test. The
10.
option causes the test frames to be initiated from one end and
initiate-and-terminate
terminated at the same end. The initiation and termination mode requires a reflector
to be configured at the peer end to return the test frames from the peer to the
originator. The option causes the test frames to be reflected on the chosen
reflect
service (IPv4, Ethernet, or bridge).
To configure the initiation and termination mode as the test mode on a router, use
the initiate-and-terminate
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode initiate-and-terminate
To configure the reflection mode as the test mode on a router, use the
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode reflect
Specify the direction (
11. egress | ingress
The option causes the test to be run in the egress direction of the interface
egress
(traffic sent from user-to-network interface (UNI) toward network-to-network
interface (NNI)). The ingress
of the interface (traffic sent on user-to-network interface (UNI)). You cannot configure
for a bridge family.
ingress
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set direction egress
Configure the outer VLAN ID for the test frames. This parameter is valid only for a CCC
12.
or an Ethernet pseudowire family.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests
option.
) of the interface on which the test must be run.
option causes the test to be run in the ingress direction
option.
reflect
1349