Juniper ACX1000 Configuration Manual page 1134

ACX Series Universal Access Router Configuration Guide
Table 81: Firewall Filter Match Conditions for VPLS Traffic (continued)
Match Condition
ipv6-payload-protocol
protocol
ipv6-payload-protocol-except
protocol
named-list
ipv6-prefix-list
address
ipv6-source-address
1076
Description
(MX Series only) Match IPv6 payload protocol type.
The following list shows the supported values for protocol:
ah—IP Security authentication header
dstopts—IPv6 destination options
egp—Exterior gateway protocol
esp—IPSec Encapsulating Security Payload
fragment—IPv6 fragment header
gre—Generic routing encapsulation
hop-by-hop—IPv6 hop by hop options
icmp—Internet Control Message Protocol
icmp6—Internet Control Message Protocol Version 6
igmp—Internet Group Management Protocol
ipip—IP in IP
ipv6—IPv6 in IP
no-next-header—IPv6 no next header
ospf—Open Shortest Path First
pim—Protocol Independent Multicast
routing—IPv6 routing header
rsvp—Resource Reservation Protocol
sctp—Stream Control Transmission Protocol
tcp—Transmission Control Protocol
udp—User Datagram Protocol
vrrp—Virtual Router Redundancy Protocol
(MX Series only) Do not match the IPv6 payload protocol.
(MX Series only) Match the IPv6 address in a named-list.
(MX Series only) 128-bit address that is the originating source node address for this packet.
Copyright © 2017, Juniper Networks, Inc.