D-Link DGS-1510 Series Reference Manual page 99

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch#configure terminal
Switch(config)# aaa authentication mac-auth default group radius
Switch(config)#
8-10 aaa authentication web-auth
This command is used to configure the default method list used for Web authentication. Use the no
form of this command to remove the default method list.
aaa authentication web-auth default METHOD1 [METHOD2...]
no aaa authentication web-auth default
Parameters
METHOD1 [METHOD2...]
Default
No AAA authentication method is configured.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the default authentication method list for Web authentication. Initially,
the default method list is not configured. The authentication of the web-auth request will be performed
based on the local database.
Example
This example shows how to set the default method list for authenticating web-auth users.
Switch#configure terminal
Switch(config)# aaa authentication web-auth default group radius
Switch(config)#
8-11 aaa group server radius
This command is used to enter the RADIUS group server configuration mode to associate server
hosts with the group. Use the no form of this command to remove a RADIUS server group
aaa group server radius GROUP-NAME
Specifies the list of methods that the authentication algorithm tries
in the given sequence. Enter at least one method or enter up to four
methods. The following are keywords that can be used to specify a
method.
local – Specifies to use the local database for authentication.
group radius – Specifies to use the servers defined by the RADIUS
server host command.
group GROUP-NAME – Specifies to use the server groups defined
by the AAA group server.
none - Normally, the method is listed as the last method. The user
will pass authentication if it is not denied by previous method
authentication.
96