D-Link DGS-1510 Series Reference Manual page 586

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to enable the router to send all STP traps to the host 10.9.18.100 using the
community string defined as public.
Switch# configure terminal
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server enable traps stp
Switch(config)# snmp-server host 10.9.18.100 version 2c public
Switch(config)#
65-5 spanning-tree global state
This command is used to enable or disable the STP's global state. Use the no form to disable the
STP's global state.
spanning-tree global state {enable | disable}
no spanning-tree global state
Parameters
enable
disable
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command in the global configuration mode to enable the global spanning-tree function.
Example
This example shows how to enable the spanning-tree function.
Switch# configure terminal
Switch(config)# spanning-tree global state enable
Switch(config)#
65-6 spanning-tree (timers)
This command is used to configure the Spanning Tree timer value. Use the no form of this command
to revert to the default settings.
spanning-tree {hello-time SECONDS | forward-time SECONDS | max-age SECONDS}
no spanning-tree {hello-time | forward-time | max-age}
Parameters
hello-time SECONDS
Specifies to enable the STP's global state.
Specifies to disable the STP's global state.
Specifies the interval that a designated port will wait between the
periodic transmissions of each configuration message. The range is
583