D-Link DGS-1510 Series Reference Manual page 530

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to display the settings and current status of the Safeguard Engine.
Switch#show cpu-protect safeguard
Safeguard Engine State: Disabled
Safeguard Engine Status: Normal
Utilization Thresholds:
Rising
Falling
Switch#
Display Parameters
Safeguard Engine Status
59-6 show cpu-protect sub-interface
This command is used to display the rate limit and statistics by sub-interface.
show cpu-protect sub-interface {manage | protocol | route} [UNIT-ID]
Parameters
UNIT-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the configured rate limit and drop count of the safeguard engine of a
specific group. These counters are counted by the software.
Example
This example shows how to display the configured rate limit and drop count of the safeguard engine
of a specific group.
:30%
:20%
Displays the current mode that CPU utilization stays. The possible
displayed strings are:
Exhausted: If the CPU utilization is higher than the configured
rising threshold, it will enter Exhausted Mode and Safeguard Engine
will take actions. The Safeguard Engine mechanism ceases till the
utilization is lower than the falling threshold.
Normal: The Safeguard Engine is not triggered to take actions.
(Optional) Specifies the unit ID to display the rate limit configuration
and statistics by sub-interface.
527