D-Link DGS-1510 Series Reference Manual page 442

Gigabit ethernet smartpro switch
Hide thumbs Also See for DGS-1510 Series:
Table of Contents

Advertisement

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
ntp peer {IP-ADDRESS | IPv6-ADDRESS} [version NUMBER] [key KEY-ID] [prefer] [min-poll
INTERVAL] [max-poll INTERVAL]
no ntp peer {IP-ADDRESS | IPv6-ADDRESS}
Parameters
IP-ADDRESS
IPv6-ADDRESS
version
NUMBER
key
KEY-ID
prefer
min-poll
INTERVAL
max-poll
INTERVAL
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The Switch's software clock can synchronize the NTP settings with a peer.
Example
This example shows how to configure the IP address of the NTP peer to 192.168.22.33 using NTP
version 3.
Switch#configure terminal
Switch(config)#ntp peer 192.168.22.33 version 3
Switch(config)#
51-9 ntp request-key
This command is used to define the key ID for NTP mode 7 packets, used by the ntpdc utility program.
Use the no form of this command to remove the key.
ntp request-key KEY-ID
Specifies the IPv4 address of the peer.
Specifies the IPv6 address of the peer.
(Optional) Specifies the NTP version number.
(Optional) Specifies to enter the NTP version number from 1 to 4.
The default version number is 4.
(Optional) Specifies the authentication key.
(Optional) Specifies to enter the authentication key ID from 1 to 255.
(Optional) Specifies to be the preferred peer for synchronization.
(Optional) Specifies the minimum poll interval for NTP messages.
This value is calculated as 2 to the power of the minimum poll
interval value specified. For example, if the value specified here is
6, the minimum poll interval that will be used is 64 seconds (2
(Optional) Specifies to enter the minimum poll interval value. The
default value is 6.
(Optional) Specifies the maximum poll interval for NTP messages.
This value is calculated as 2 to the power of the maximum poll
interval value specified. For example, if the value specified here is
6, the maximum poll interval that will be used is 64 seconds (2
(Optional) Specifies to enter the maximum poll interval value. The
default value is 10.
439
6
=64).
6
=64).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents