D-Link DGS-1510 Series Reference Manual page 531

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show cpu-protect sub-interface manage
Sub-Interface: manage
Rate Limit : 1000 pps
Unit
--------------
1
3
Switch#
59-7 show cpu-protect type
This command is used to display the rate limit and statistics of CPU protection.
show cpu-protect type {PROTOCOL-NAME [UNIT-ID] | unit UNIT-ID}
Parameters
PROTOCOL-NAME [UNIT-ID]
unit UNIT-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the rate limit and statistics of the safeguard engine.
Example
This example shows how to display the rate limit and statistics of the safeguard engine.
Switch# show cpu-protect type arp
Type: arp
Rate Limit: 300
Unit
--------------
1
3
Switch#
Total Drop
--------- ---------
50 0
50 0
Specifies that the configured rate limit and statistics of the specified
protocol on the CM-card and all existing IO-cards will be displayed if
the optional unit ID is not specified. Otherwise, only the information
on the specified unit ID will be displayed.
Specifies the unit ID to display the rate limit configuration and
statistics.
pps
Total Drop
--------- ---------
30 0
30 0
528