D-Link DGS-1510 Series Reference Manual page 656

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
PROFILE-ID
ethernet2
snap
llc
ether-type TYPE-VALUE
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create or delete a protocol group.
Example
This example shows how to create a protocol VLAN group with a group ID "10".
Switch# configure terminal
Switch(config)# protocol-vlan profile 10 frame-type ethernet2 ether-type 0x86dd
Switch(config)#
75-14 protocol-vlan profile (interface)
This command is used to configure the VLAN classification entry for a protocol group on a port. Use
the no form of this command to remove the VLAN classification entry on a port.
protocol-vlan profile PROFILE-ID vlan VLAN-ID [priority COS-VALUE]
no protocol-vlan profile PROFILE-ID
Parameters
PROFILE-ID
VLAN-ID
priority COS-VALUE
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the ID of the protocol group.
Specifies the type of the Ethernet II frames.
Specifies the type of the SNAP frames.
Specifies the type of the LLC frames.
Specifies the Ethernet type. The value should be 2 bytes in
hexadecimal form.
Specifies the ID of the protocol group.
Specifies the VLAN ID of the protocol VLAN. Only one VLAN ID can
be specified for each binding group.
(Optional) Specifies the priority. If not specified, the priority is 0.
653