D-Link DGS-1510 Series Reference Manual page 126

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show ipv6 interface brief
vlan1 is up, Link status is up
FE80::201:1FF:FE02:304
vlan2 is up, Link status is down
FE80::201:1FF:FE02:305
200::2
vlan3 is up, Link status is down
FE80::201:1FF:FE02:306
Total Entries: 3
Switch#
10-8 show ipv6 neighbors
This command is used to display IPv6 neighbor information.
show ipv6 neighbors [INTERFACE-ID] [IPV6-ADDRESS]
Parameters
IPV6-ADDRESS
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the IPv6 neighbor cache entry.
Example
This example shows how to display the IPv6 neighbor cache entry.
Switch# show ipv6 neighbors
IPv6 Address
-------------------------------------- ----------------- --------- ---- -----
FE80::200:11FF:FE22:3344
Total Entries: 1
Switch#
Display Parameters
Specifies the IPv6 address to display its IPv6 neighbor cache entry.
Specifies the interface to display IPv6 neighbor cache entry.
Link-Layer Addr
00-00-11-22-33-44 vlan1
123
Interface Type State
D REACH