D-Link DGS-1510 Series Reference Manual page 505

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
56-23 show mls qos aggregate-policer
This command is used to display the configured aggregated policer.
show mls qos aggregate-policer [NAME]
Parameters
NAME
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the configured aggregated policer.
Example
This example shows how to display the aggregate policer.
Switch# show mls qos aggregate-policer
mls qos aggregate-policer agg-policer5 10 1000 conform-action transmit exceed-
action drop
mls qos aggregate-policer agg-policer5 cir 500 bc 10 pir 1000 be 10 conform-action
transmit exceed-action set-dscp-transmit 2 violate-action drop
Switch#
56-24 show mls qos interface
This command is used to display port level QoS configurations.
show mls qos interface INTERFACE-ID [, | -] {cos | scheduler | trust | rate-limit | queue-rate-
limit | dscp-mutation | map {dscp-color | cos-color | dscp-cos}}
Parameters
interface INTERFACE-ID
,
-
cos
scheduler
trust
(Optional) Specifies the name of the aggregate policer.
Specifies the interface ID to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Specifies to displays the port default CoS.
Specifies to displays the transmit queue scheduling settings.
Specifies to displays the port trust State.
502