D-Link DGS-1510 Series Reference Manual page 560

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Usage Guideline
Use this command to disable the port to send SNMP notification traps out of the configured port. If the
sending is disabled, then SNMP notification traps generated by the system are not allowed to transmit
out of the port. The SNMP traps generated by other system and forwarded to the port is not subject to
this restriction.
Example
This example shows how to disable the sending of the notification traps out of Ethernet interface
eth3/0/8.
Switch# configure terminal
Switch(config)# interface eth3/0/8
Switch(config-if)# snmp-server trap-sending disable
Switch(config-if)#
63-11 snmp-server service-port
This command is used to configure the SNMP UDP port number. Use the no form of this command to
reset the UDP port number to default value.
snmp-server service-port PORT-NUMBER
no snmp-server service-port
Parameters
PORT-NUMBER
Default
By default, this number is 161.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the SNNP UDP port number on the Switch. The agent will listen to the
SNMP request packets on the configured service UDP port number.
Example
This example shows how to configure the SNMP UDP port number.
Switch# configure terminal
Switch(config)# snmp-server service-port 50000
Switch(config)#
63-12 snmp-server response broadcast-request
This command is used to enable the server to response to broadcast SNMP GetRequest packets.
Use the no form of this command to disable the response to broadcast SNMP GetRequest packets.
snmp-server response broadcast-request
Specifies the UDP port number. The range is from 0 to 65535.
Some numbers may conflict with other protocols.
557