D-Link DGS-1510 Series Reference Manual page 352

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
42-5 port-channel load-balance
This command is used to configure the load balance algorithm that the Switch uses to distribute
packets across ports in the same channel. Use the no form of this command to revert to the default
setting.
port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac}
no port-channel load-balance
Parameters
dst-ip
dst-mac
src-dst-ip
src-dst-mac
src-ip
src-mac
Default
The default load balance algorithm is src- mac.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to specify the load balance algorithm. Only one algorithm can be specified.
Example
This example shows how to configure the load balance algorithm as src-ip.
Switch# configure terminal
Switch(config)# port-channel load-balance src-ip
Switch(config)#
42-6 show channel-group
This command is used to display the channel group information.
show channel-group [channel [CHANNEL-NO] {detail | neighbor} | load-balance | sys-id]
Parameters
CHANNEL-NO
channel
Specifies that the Switch should examine the IP destination
address.
Specifies that the Switch should examine the MAC destination
address.
Specifies that the Switch should examine the IP source address and
IP destination address.
Specifies that the Switch should examine the MAC source and MAC
destination address.
Specifies that the Switch should examine the IP source address.
Specifies that the Switch should examine the MAC source address.
(Optional) Specifies the channel group ID.
(Optional) Specifies to display information for the specified port-
channels.
349