D-Link DGS-1510 Series Reference Manual page 462

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable sending PoE usage threshold exceeding traps.
Example
This example shows how to enable trap for PoE event.
Switch#configure terminal
Switch(config)#snmp-server enable traps poe
Switch(config)#
53-8 clear poe statistic
This command is used to clear the statistic counters on the port.
clear poe statistic {all | interface INTERFACE-ID [,|-]}
Parameters
all
interface INTERFACE-ID
,
-
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
There are counters on ports to record the statistic and they can be shown by show poe power-inline
statistics command. Use this command to clear all the counter values on the port.
Example
This example shows how to clear statistics on interface eth3/0/1.
only available, if stacking is enabled.
Specifies to clear PoE statistics for all interfaces.
Specifies the interface ID of an interface.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
459