D-Link DGS-1510 Series Reference Manual page 464

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show poe power-inline status
Interface
-----------------------------------------------------------------------------
eth3/0/1
eth3/0/2
!--- Output suppressed...
eth4/0/1
eth4/0/2
eth4/0/3
eth4/0/4
!--- Output suppressed...
eth5/0/24
eth5/0/25
Faulty code:
[1] MPS (Maintain Power Signature) Absent
[2] PD short
[3] Overload
[4] Power Denied
[5] Thermal Shutdown
[6] Startup Failure
[7] Classification Failure
Switch#
Display Parameters
Interface
State
Class
Max(W)
Used(W)
Description
Example
This example shows how to display the PoE power inline configuration.
State Class Max(W) Used(W) Description
delivering class-1 4
delivering class-2 10
delivering class-3 15.4
delivering class-3 15.4
disabled n/a 0
searching n/a 11.0
disabled n/a 0
faulty[2] n/a
The PoE interface ID.
The port status can be of the following:
Disabled: The PSE function is disabled.
Searching: The remote PD is not connected.
Requesting: The remote PD is inserted, but the PSE doesn't
provide power yet.
Delivering: The remote PD is now powering by PoE system.
Faulty[X]: The device detection or a powered device is in a faulty
state. X is the error code number.







The IEEE classification: N/A or a value from IEEE class 0 to 4.
The maximum amount of power could be allocated to the powered
device in watts.
The amount of power is currently allocated to PoE ports in watts.
The configured description of the connected PD.
3.4 IP-camera-1
6.3 12345678901234567890123456789012
13.0
12.4
0
0
0
0 0
[1] - MPS (Maintain Power Signature) Absent.
[2] - PD Short.
[3] - Overload.
[4] - Power Denied.
[5] - Thermal Shutdown.
[6] - Startup Failure.
[7] - Classification Failure(IEEE 802.3at).
461