D-Link DGS-1510 Series Reference Manual page 372

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch#show lldp interface ethernet 1/0/1
Port ID: eth1/0/1
------------------------------------------------------------------------------
Port ID
Admin Status
Notification
Basic Management TLVs:
Port Description
System Name
System Description
System Capabilities
Enabled Management Address:
(None)
IEEE 802.1 Organizationally Specific TLVs:
Port VLAN ID
Enabled Port_and_Protocol_VLAN_ID
1, 2, 3
Enabled VLAN Name
1-3
Enabled Protocol_Identity
EAPOL, LACP, GVRP, STP
IEEE 802.3 Organizationally Specific TLVs:
MAC/PHY Configuration/Status
Link Aggregation
Maximum Frame Size
LLDP-MED Organizationally Specific TLVs:
LLDP-MED Capabilities TLV
LLDP-MED Network Policy TLV
LLDP-MED Extended Power Via MDI PSE TLV
LLDP-MED Inventory TLV
Switch#
Display Parameters
Enabled Management
Address
Enabled Port and Protocol
VLAN ID
Enabled VLAN Name
Enabled Protocol Identity
Displays the enabled IPv4/IPv6 addresses. The indicated string
"(None)" means that the user did not configure the management
address with the lldp management-address command or the
enabled default IPv4 and IPv6 addresses are not applicable.
This indicating string is shown when there are enabled port and
protocol VLANs. The VLAN list is the configured enabled VLANs. If
there is no configured PPVID VLAN, the string is "(None)".
This indicating string is shown when there are enabled VLANs for
sending VLAN Name TLVs. The VLAN list includes the configured
enabled VLANs. If there is no configured VLAN for the VLAN Name
TLV, the string is "(None)".
Displays the enabled protocol string for protocol identity TLVs. If
there is no enabled protocol for protocol identity TLVs, the string is
"(None)".
369
:eth1/0/1
:TX and RX
:Disabled
:Enabled
:Enabled
:Enabled
:Enabled
:Enabled
:Enabled
:Disabled
:Disabled
:Enabled
:Disabled
:Disabled
:Disabled