D-Link DGS-1510 Series Reference Manual page 431

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
any
mac-jwac
mac-wac
Default
By default the authentication method is any.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for physical port interface configuration. Use this command to
configure the authentication method on ports.
The enable or disable setting of individual authentication will always take effect. If the compound
authentication method of a port is set to any but MAC-based Access Control is disabled, and JWAC
and 802.1X are enabled, then user must pass either the JWAC or 802.1X method. If the method is
mac-jwac or mac-wac, the user is authorized after two methods are authenticate passed. If any of
the methods failed, the user is rejected. If the related method's global or port state is not enabled, the
user is rejected (due to not authenticated pass). After authenticated, the authorized information will
take from JWAC or WAC module.
Example
This example shows how to configure Ethernet port 1/0/6 in mac-jwac mode.
Switch#configure terminal
Switch(config)#mac-auth system-auth-control
Switch(config)#jwac system-auth-control
Switch(config)#interface eth1/0/6
Switch(config-if)#mac-auth enable
Switch(config-if)#jwac enable
Switch(config-if)#
50-11 authentication max users
This command is used to configure the maximum authenticated users for the entire system or for a
port. Use the no form of this command to revert to the default settings.
authentication max users NUMBER
no authentication max users
Parameters
NUMBER
Default
None.
Specifies that if any of the authentication method (802.1X, MAC-
based Access Control, WAC, or JWAC) to passes, then pass.
Specifies to verify MAC-based authentication first. If the client
passes, JWAC will be verified next. Both authentication methods
need to be passed.
Specifies to verify MAC-based authentication first. If the client
passes, WAC will be verified next. Both authentication methods
need to be passed.
Specifies to set the maximum authenticated users' number. The
range is from 1 to 1000.
428