D-Link DGS-1510 Series Reference Manual page 303

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to display the NULL interface information for interface null0.
Switch# show interfaces null0
Null0 is enabled, link status is up
Interface type: Null
Interface description: Null0 for MIS
Switch#
This example shows how to display the interface information for eth1/0/1.
Switch#show interfaces eth1/0/1
Eth1/0/1 is enabled, link status is up
Interface type: 1000BASE-T
Interface description:
MAC Address: 00-01-02-03-04-01
Auto-duplex, auto-speed, auto-mdix
Send flow-control: off, receive flow-control: off
Send flow-control oper: off, receive flow-control oper: off
Full-duplex, 1Gb/s
Maximum transmit unit: 1536 bytes
Rx rate: 0 bytes/sec, TX rate: 0 bytes/sec
RX bytes: 116316, TX bytes: 132495
RX rate: 0 packets/sec, TX rate: 0 packets/sec
RX packets: 1213, TX packets: 365
RX multicast: 774, RX broadcast: 439
RX CRC error: 0, RX undersize: 0
RX oversize: 0, RX fragment: 0
RX jabber: 0, RX dropped Pkts: 1212
RX MTU exceeded: 0
TX CRC error: 0, TX excessive deferral: 0
TX single collision: 0, TX excessive collision: 0
TX late collision: 0, TX collision:0
Switch#
34-7 show interfaces counters
This command is used to display counters on specified interfaces.
show interfaces [INTERFACE-ID [,|-]] counters [errors]
Parameters
errors
INTERFACE-ID
Default
None.
Command Mode
(Optional) Specifies to display the error counters.
(Optional) Specifies that the interface can be a physical port. If no
interface is specified, the counters on all interfaces will be
displayed.
300