D-Link DGS-1510 Series Reference Manual page 360

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
VALUE
Default
By default, this value is 4.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This parameter is a multiplier on the LLDPDUs transmission interval that is used to compute the TTL
value in an LLDPDU. The lifetime is determined by the hold-multiplier times the TX-interval. At the
partner switch, when the TTL for a given advertisement expires, the advertised data is deleted from
the neighbor switch's MIB.
Example
This example shows how to configure the LLDP hold-multiplier to 3.
Switch# configure terminal
Switch(config)# lldp hold-multiplier 3
Switch(config)#
43-7 lldp management-address
This command is used to configure the management address that will be advertised on the physical
interface. Use the no form of this command to remove the settings.
lldp management-address [IP-ADDRESS | IPV6-ADDRESS]
no lldp management-address [IP-ADDRESS | IPV6-ADDRESS]
Parameters
IP-ADDRESS
IPV6-ADDRESS
Default
No LLDP management address is configured (no Management Address TLV is sent).
Command Mode
Interface Configuration Mode.
Command Default Level
Level:12.
Usage Guideline
This command is available for physical port configuration. This command specifies the IPv4/IPv6
address that is carried in the management address TLV on the specified port. If an IP address is
specified, but the address is not one of the addresses of the system interfaces, then the address will
not be sent.
Specifies the multiplier on the LLDPDUs transmission interval that
used to compute the TTL value of an LLDPDU. This value must be
between 2 and 10.
(Optional) Specifies the IPv4 address that is carried in the
management address TLV.
(Optional) Specifies the IPv6 address that is carried in the
management address TLV.
357