DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the proxy ARP state for an interface. When proxy ARP is enabled, the
system will respond to ARP requests for IP addresses within the local connected subnets. Proxy ARP
can be used in the network where hosts have no default gateway configured.
Example
This example shows how to enable proxy the ARP feature on the interface of VLAN 100.
Switch# configure terminal
Switch(config)# interface vlan100
Switch(config-if)# ip proxy-arp
Switch(config-if)#
9-6 ip local-proxy-arp
This command is used to enable the local proxy ARP feature on an interface. Use the no form of this
command to revert to the default setting.
ip local-proxy-arp
no ip local-proxy-arp
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the local proxy ARP function on an interface. This command is used in
the primary VLAN of a private VLAN domain to enable routing of packets among secondary VLANs or
isolated ports within the domain. The command only take effects when ip proxy arp is enabled.
Example
This example shows how to enable local proxy ARP on VLAN100.
114