D-Link DGS-1510 Series Reference Manual page 86

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# no username admin
Switch(config)#
5-24 password
This command is used to create a new password. Use the no form of this command remove the
password.
password [0 | 7 | 15] PASSWORD
no password
Parameters
0
7
15
PASSWORD
Default
None.
Command Mode
Line Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is used to create a new user password. Only one password can be used for each type
of line.
Example
This example shows how to create a password for the console line.
Switch# configure terminal
Switch(config)# line console
Switch(config-line)# password 123
Switch(config-line)#
5-25 clear line
This command is used to disconnect an active session on the switch.
Specifies the password in clear, plain text. The password length is
between 1 and 32 characters and can contain embedded spaces. It
is case-sensitive. If the password syntax cannot be specified, the
syntax remains plain text.
Specifies the encrypted password based on SHA-1. The password
length is fixed at 35 bytes. It is case-sensitive. The password is
encrypted. If the password syntax is not specified, the syntax is
plain text.
Specifies the encrypted password based on MD5. The password
length is fixed at 31 bytes. It is case-sensitive. The password is
encrypted. If the password syntax is not specified, the syntax is
plain text.
Specifies the password for the user.
83