D-Link DGS-1510 Series Reference Manual page 266

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# show mac-address-table learning interface ethernet 1/0/1-10
Interface
------------------------
eth1/0/1
eth1/0/2
eth1/0/3
eth1/0/4
eth1/0/5
eth1/0/6
eth1/0/7
eth1/0/8
eth1/0/9
eth1/0/10
Switch#
30-11 show mac-address-table notification change
This command is used to display the MAC address notification configuration or history content.
show mac-address-table notification change [interface [INTERFACE-ID] | history]
Parameters
interface INTERFACE-ID
history
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no option is specified, the global configuration will be displayed. Use the interface keyword to
display information about all interfaces. If the interface ID is included, the specified interface will be
displayed.
Example
This example shows how to display the MAC address notification change configuration on all
interfaces.
State
--------
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
(Optional) Specifies the interface to display.
(Optional) Specifies to display the MAC address notification change
history.
263