D-Link DGS-1510 Series Reference Manual page 397

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
For a VLAN to operate with MLD snooping, both the global state and per interface state must be
enabled. On a VLAN, the setting of IGMP snooping and MLD snooping are independent. That is,
IGMP snooping and MLD snooping can be simultaneously enabled on the same VLAN.
Example
This example shows how to disable MLD snooping globally.
Switch# configure terminal
Switch(config)# no ipv6 mld snooping
Switch(config)#
This example shows how to enable MLD snooping globally.
Switch# configure terminal
Switch(config)# ipv6 mld snooping
Switch(config)#
This example shows how to enable MLD snooping on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ipv6 mld snooping
Switch(config-vlan)#
47-3 ipv6 mld snooping fast-leave
This command is used to configure MLD snooping fast-leave on the interface. Use the no form of this
command to disable the fast-leave option on the specified interface.
ipv6 mld snooping fast-leave
no ipv6 mld snooping fast-leave
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for VLAN interface configuration. The ipv6 mld snooping fast-leave
command allows MLD membership to be immediately removed from a port when receiving the leave
message without using the group specific or group-source specific query mechanism.
Example
This example shows how to enable MLD snooping fast-leave on VLAN 1.
394