D-Link DGS-1510 Series Reference Manual page 633

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the system messages logged in the local message buffer.
Each message logged in the message buffer is associated with a sequence number. As a message is
logged, a sequence number starting from 1 is allocated. The sequence number will roll back to 1
when it reaches 100000.
When the user specifies to display a number of messages following the reference sequence number,
the oldest messages are displayed prior to the newer messages. When the user specifies to display a
number of messages prior to the reference sequence number, the newer messages are displayed
prior to the later messages.
If the command is issued without options, the system will display up to 200 entries starting from the
latest message.
Example
This example shows how to display the messages in the local message buffer.
switch# show logging
Total number of buffered messages: 2
#2 2013-08-02 16:37:36 INFO(6) Logout through Console (Username: Anonymous)
#1 2013-08-02 16:35:54 INFO(6) Port eth1/0/1 link up, 1000Mbps FULL duplex
switch#
71-8 show attack-logging
This command is used to display attack log messages.
show attack-logging unit UNIT-ID [index INDEX]
Parameters
UNIT-ID
INDEX
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the attack log messages. The attack log message refers to log
messages driven by modules such as DOS and the port-security module. This type of log message
may generate a large amount of messages and quickly cause the system to run out of system log
Specifies the unit on which the attack log messages will be
displayed.
Specifies the list of index numbers of the entries that need to be
displayed. If no index is specified, all entries in the attack log DB will
be displayed.
630