D-Link DGS-1510 Series Reference Manual page 513

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
56-28 wdrr-queue bandwidth
This command is used to set the queue quantum in the WDRR scheduling mode. Use the no form of
this command to revert to the default setting.
wdrr-queue bandwidth QUANTUM1...QUANTUM127
no wdrr-queue bandwidth
Parameters
QUANTUM1 ...QUANTUM127
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The configuration of this command takes effect when the scheduling mode is in the WDRR mode. Use
the mls qos scheduler wdrr command to change the scheduling mode to WDRR mode.
Example
This example shows how to configure the queue quantum of the WDRR scheduling mode, queue
quantum of queue 0, queue 1, queue 2, queue 3, queue 4, queue 5, queue 6, queue 7 are 1, 2, 3, 4, 5,
6, 7, 8 respectively on interface eth3/0/1.
Switch# configure terminal
Switch(config)# interface eth3/0/1
Switch(config-if)# mls qos scheduler wdrr
Switch(config-if)# wdrr-queue bandwidth 1 2 3 4 5 6 7 8
Switch(config-if)#
56-29 wrr-queue bandwidth
This command is used to set the queue weight in the WRR scheduling mode. Use the no form of this
command to revert to the default setting.
wrr-queue bandwidth WEIGHT1...WEIGHT127
no wrr-queue bandwidth
Parameters
WEIGHT1 ...WEIGHT127
Default
None.
Command Mode
Specifies the quantum (frame length count) value of every queue
for weighted round-robin scheduling.
Specifies the weight (frame count) value of every queue for
weighted round-robin scheduling.
510